bridge

All, I have a few questions. My home system is using a bridge for various reasons, mostly to enable my VMS in BHyve to access the outside world through tap0. My rc.conf and pf.conf are below. When I use this setup, my VMS can connect out and receive addresses on the network. When I reboot...

I am trying to share a single 10Gb ethernet outlet in my office between two machines by bridging across a FreeBSD server using the second port on its 10Gb card. The bridge works quite well, and the other machine gets network service. The FreeBSD server, however, does not, even though I added an...

Hi, My server have two physical ethernet ports. On igb0 comes tagged vlan traffic. I want igb1 to be used as a normal switch port with untagged traffix from vlan 1 so that I can connect my old network printer without using an additional physical network switch. This is relevant parts of my...

Howdy! I want to run Suricata in NETMAP mode on interface ix0, while bridging traffic from ix0 to ix1. The question is why does Suricata completely break the FreeBSD bridge when run in netmap mode, and more to the point, how should one configure Suricata to watch ix0 while also passing traffic...