Solved VPN Client Connection Question

A

animortis

I am attempting to connect to a NordVPN ovpn file using the cli command 'sudo openvpn filname.ovpn." However, once the connection is established, the entire internet connection cuts out. No firewall is enabled. ifconfig shows the wired connection as re0.

I'd provide more information, but I don't know where to start to figure out the problem. Somewhat of a newbie. I will note that a few weeks ago this seemed to work just fine, so I'm wondering if there's a flag on the port that might be valuable.

FreeBSD localhost 12.2-STABLE FreeBSD 12.2-STABLE GENERIC amd64
Click to expand...
 
So just an FYI on the record as I wasn't expecting much on this, apparently at some point it was changed from the original 'openvpn' command to 'openvpn-client.' Switching to that command did it for me. Took a lot of Google-fu. Thank you.
 
You must log in or register to reply here.
Back
Top