I have a Dell PowerEdge R200 running FreeNAS 9.10 with an Adaptec 1045. I have 4 1 TB SATA Drives on the Adaptec controller.
The drives are recognized in the BIOS, but not by FreeNAS.
On Adaptec's website there are drivers for Suse and Red Hat, But I can't install any RPM's on FreeNAS.
There is also the source code for it here.
When I try compiling it I get Error 1 because the directory /lib/modules/`uname -r`/build is non-existent. If I make that directory it gives Error 2 saying it can't make it.
Next I tried what was stated in this thread: https://forums.freenas.org/index.php?threads/adaptec-6805-driver-issue-shutdown.5526/
Click to expand...
But in my case I extracted an rpm and found adpinv.ko and did
However this doen't load, and upon trying kldload adpinv it says to check dmesg, Dmesg provides a very generic response. HAS ANYONE GOTTEN THIS TO WORK?!?!
The drives are recognized in the BIOS, but not by FreeNAS.
On Adaptec's website there are drivers for Suse and Red Hat, But I can't install any RPM's on FreeNAS.
There is also the source code for it here.
When I try compiling it I get Error 1 because the directory /lib/modules/`uname -r`/build is non-existent. If I make that directory it gives Error 2 saying it can't make it.
Next I tried what was stated in this thread: https://forums.freenas.org/index.php?threads/adaptec-6805-driver-issue-shutdown.5526/
I set the HDDs as JBOD and they appear in the HDD list and the ZFS raid works normally.
Click to expand...
But in my case I extracted an rpm and found adpinv.ko and did
Code:
cp adpinv.ko into /boot/kernel
manually edited the /boot/loader.conf and added
adpinv_load=”YES”However this doen't load, and upon trying kldload adpinv it says to check dmesg, Dmesg provides a very generic response. HAS ANYONE GOTTEN THIS TO WORK?!?!
