mellanox

I've been wrestling with a Mellanox ConnectX-3 trying to make SR-IOV work on FreeBSD. I've completed the (unnecessarily difficult) process to create a custom firmware configuration with SR-IOV enabled, burning the configuration/firmware to the card, etc. However, when the card is reinstalled in...

Today, I received a Dell MCX314A-BCCT 40Gb QSFP+ NIC and flashed it with the latest firmware from Mellanox. However, I noticed that there are no devices listed in /dev/iov. I installed mft-4.22.1-417 and confirmed that mlxconfig show SRIOV_EN=1. Despite this, I'm still unable to get it...

# dmesg -a ... mlx5_core0: <mlx5_core> mem 0xc2000000-0xc3ffffff at device 0.1 numa-domain 5 on pci35 msi_map: unsupported destination APIC ID 324 mlx5_core0: WARN: mlx5_start_eqs:577:(pid 62837): failed to create cmd EQ -22 mlx5_core0: ERR: mlx5_load_one:1197:(pid 62837): Failed to start pages...

Hi all. I am trying to get IPoIB working between FreeBSD (synced to 14.x) and a Linux host. I have enabled the following: options IPOIB_CM options SDP device mlx5 # Mellanox CX5/CX6 NIC device mlxfw # Mellanox Monolithic firmware update device...

While trying to setup SR-IOV VFs on a Mellanox ConnectX-4 100G NIC I'm getting a kernel panic. I've run the appropriate commands to enable VFs and the desired quantity via the mellanox firmware tool, as documented in their user guide. Then I setup the /etc/iov/mce1.conf file to contain the...

Hey everyone, I am wondering if the dual port connectx-2 would work in FreeBSD 11.2? If so, would it simply be plug in the NIC and use it or would I have to compile the driver. I have heard that the single port version works in FreeNAS without any tinkering (plug it in, set an IP, and use it)...

Hello I saw in old threads that the Mellanox ConnectX 10GB PCIe card was supported... but when enabling those drivers trying to build a custom 11 kernel the build fails... Is this card no longer supported in FreeBSD 11.0 anymore? none3@pci0:9:0:0: class=0x020000 card=0x002115b3...