dnsmasq

Hi all, I am having an odd situation where my SSH sessions take ages to reach the prompt. For example it takes 30 seconds to run the below: $ time ssh root@techanalysis "echo ok" ok real 0m30,422s user 0m0,142s sys 0m0,000s The same command when run with the IP address is much...

Hi, My setup is like following. server1 = primary server setup with carp, it is running the dnsmasq and it is also the gateway for my local network 192.168.1.0/24 server2= secondary server setup with carp, it is also running the dnsmasq (/var/db/dnsmasq.leases is copied from server1) and it is...

I try to make NAT for two LAN network interfaces. But NAT client cannot go out to WAN side network. pf.conf # interfaces wan_if="alc0" wl1_if="wlan1" # 10.0.0.254, interface wlan1 as Access Point ue0_if="ue0" # 10.0.0.1, connect to L2 switch lan_if="{" $wl1_if $ue0_if "}"...

I have a similiar behavior like mentioned in an older post. Whenever I try to run pkg update I receive a timeout: Updating FreeBSD repository catalogue... pkg: http://pkg.freebsd.org/FreeBSD:12:amd64/quarterly/meta.txz: Operation timed out...

I have an AP+bridge+firewall ("router") running FreeBSD 12.2-RELEASE r366954 GENERIC amd64. It's roughly set up as follows: - igb0 connects to my ISP via DHCP. (Disabled while I debug this.) - bridge0 has dnsmasq running on it as a DHCP server and DNS server. (Only dynamic addresses at the...

After upgrading from FreeBSD-11.2 to FreeBSD-11.3, access to the dnsmasq TFTP service does not seem to be working any longer. The problem seems to be related somehow to the kernel as shown below: 1. Install FreeBSD-11.2 2. Install, configure and enable dnsmasq TFTP service as follows: in...

Hello All, I am attempting to find out what my issue is with my FreeBSD Router that I am attempting to build. I have set up the following tools on my OS on my router: HostAPD DNSMasq PF All of which appear to work and I can route through the AP. However; I am not getting nearly the speeds or...

Over the last 3 years or so I have used dnsmasq as a recursive DNS server within my home network. Using the below settings and the DHCP service within my SOHO router to assign IP address's and the DNS address to my dnsmasq server. This has worked great with just about any device tossed on my...

Hi, Am using dns/dnsmasq as a local service. On boot I see an error message stating that the service can not start because of a missing file, libnettle.so.6. Once the system logins in and service dnsmasq start is used the service begins. Also I get positive results for find /usr/ -name...