3d printing

Would like to install LaserGRBL on FreeBSD 13.1 so that I can use it along with my 3D printer Ender-3 with 4.2.7 board. The laser module is custom made using UV laser of 25mW Sony Diode. https://github.com/arkypita/LaserGRBL I'm going to make PCBs with it using UV dry film photo resit, known...

Hello, its nice that theres a port for Cura and Prusa Slicer but I like to use programs that are written in C++ so that I can port it into microcontrollers and it's also easier to maintain. The issue with Prusa Slicer is that it does not have inner hole horizontal expansion compensation. Super...

I am trying to port a 3D printer firmware / daemon called Klipper to run on FreeBSD. So far it all went well until it wanted to <linux/can.h> I am running out of places to look for that file. I don't see it anywhere in the standard libraries. Is there canbus support in FreeBSD? If so, where can...

I installed cura (3D printing slicer from Ultimaker) with pkg on FreeBSD 12.2 (amd64). I use KDE Plasma 5.20 (if this is relevant). Cura starts but it freezes: I can't click anything (already tried Enter and Tab + Enter). Terminal output: https://pastebin.com/6fr32ST7 Any way to fix thix...